Other Pliers

Diagonal pliers or wire cutters are wire-cutting pliers. They are sometimes called side cutting pliers or side cutters, although these terms are shared by other pliers designs and may lead to confusion. more...

Home
Building & Hardware
Dining & Bar
Electrical & Solar
Food & Wine
Heating, Cooling & Air
Home Security
Kitchen
Major Appliances
Outdoor Power Equipment
Plumbing & Fixtures
Tools
Air Compressors
Air Tools
Flashlights
Generators, Home-Use
Hand Tools
Clamps & Vises
Bar Clamps
Bench, Table Vises
Other Clamps & Vises
Spring & C-Clamps
Files & Chisels
Hammers
Knives & Cutters
Other Knives & Cutters
Pocket Knives & Cutters
Utility Knives & Cutters
Leatherworking Tools
Levels & Plumb Bobs
Laser Levels
Other Levels & Plumb Bobs
Standard Levels
Measuring Tools
Calipers
Measuring Tapes & Rulers
Other Measuring Tools
Squares
Mixed Tool Sets
Other Hand Tools
Planes
Pliers
Other Pliers
Plier Sets
Single Pliers
Pry Bars
Pullers
Punches
Saws
Screwdrivers
Craftsman Sets
Other Screwdriver Sets
Other Screwdrivers
Screwdriver Sets
Single Screwdrivers
Snap-On Sets
Stanley Sets
Winches
Wrenches
Adjustable Wrenches
Allen & Hex Wrenches
Other Wrenches
Pipe Wrenches
Socket Wrenches
Torque Wrenches
Wrench Sets
Meters, Testers & Probes
Other Tools
Power Tools
Safety, Protective Gear
Tie Downs, Straps
Tool Boxes, Belts & Storage
Welding & Soldering Tools
Vacuum Cleaners &...
Wholesale Lots
Window Treatments

The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a diagonal", hence the name. Instead of using a shearing action as with scissors, they cut by indenting and wedging the wire apart. The jaw edges are ground to a symmetrical "V" shape, thus the two jaws can be visualized to form the letter "X", as seen end-on when fully occluded. The pliers are made of tempered steel and inductive heating and quenching is often used to selectively harden the jaws.

Dikes — as in the phrase "a pair of dikes" — is jargon used especially in the electrical industry, to describe diagonal pliers. It is a corruption of "diagonal cutters".

Applications

Diagonal pliers are useful for cutting copper, brass, iron and steel wire. Lower quality versions are generally not suitable for cutting tempered steel, such as piano wire, as the jaws are typically not hard enough. Attempting to cut such material will usually cause indentations to be made in the jaws, or a piece to break out of one or both jaws, thus ruining the tool. However higher quality side cutters can cut hardened steel, such as 2 mm piano wire.

For electronics work, special diagonal cutters that are ground flush to the apex of the cutting edge on one side of the jaws are often used. These flush-cutting pliers allow wires to be trimmed flush or nearly flush to a solder joint, avoiding the sharp tip left by symmetrical diagonal cutters.

Read more at Wikipedia.org